Table of Contents
Advertisement
Symptom
Live indicator keeps on
blinking orange approx. in 2
seconds intervals.
Live indicator never lights up.
Live indicator keeps on
blinking red.
Live indicator lights red.
Audio input contains noise.
• UPnP
TM
error has occurred since the power is not supplied to the
router.
Turn on the power of the router. Wait until the connections are
established.
• An error has occurred during the port update by the UPnP func-
tion.
If the router in use does not support the UPnP function, perform
the port forwarding setting for the router. In addition, deactivate the
setting of auto port forwarding for the camera.
• UPnP function of the router is disabled.
Refer to the operating instructions of the router to enable the
UPnP function.
• Is "Off" selected for "Link/Access LED" on the "Basic" page?
Select "On" or "On(Access)" for the indicator setting.
• The camera may be out of order.
Contact your dealer.
• Refer to the readme file on the provided CD-ROM for further infor-
mation after checking the displayed contents of the "Maintenance"
page - the [Status] tab - "Self check" of the setup menu.
• Isn't the write protect switch of the inserted SD memory card set
to "LOCK"?
Unlock the write protect switch of the SD memory card.
• Hasn't the inserted SD memory card been formatted on a PC?
Use an SD memory card formatted on the camera.
Or install the software to format the SD memory card on the PC.
Refer to our website
(http://security.panasonic.com/pss/security/support/info.html)
for further information about the supported software.
• Isn't the inserted SD memory card faulty?
Replace the card with a normal one.
• Check the following.
• G rounding of the camera, a switching hub or peripheral devices
are not done.
• The camera is used near an electrical power line.
• T he camera is used near a device which produces strong mag-
netic field or radio waves (such as near a TV/radio antenna, a
motor of an air conditioning system, a transformer, etc.)
When audio input still contains noise even after checking the
above possibilities, use a powered microphone or connect audio
output with low output impedance.
Cause/solution
Reference
pages
−
Operating
Instructions
(included in
the CD-ROM)
−
Operating
Instructions
(included in
the CD-ROM)
−
Operating
Instructions
(included in
the CD-ROM)
12
29
Advertisement
Table of Contents
