Table of Contents
Advertisement
r Turn the decorative cover a further 16 ° in the direc-
tion of the arrow (clockwise) as illustrated to secure
the cover.
t Make sure that all of the end part of the locking arm
has come out from the hole in the decorative cover.
r
(Approx. 16 °)
Step 11
Remove the cover film from the lens after the installation is
complete.
Wire without making a hole in the
ceiling
Install the camera by following step 1 and steps 3 - 9 of the
"Wire through a hole in the ceiling" section (☞ pages 19-22).
It is unnecessary to make a hole in the ceiling as described in
step 2 of the "Wire through a hole in the ceiling" section.
Remove the cutout part on the decorative cover (accessory).
Locking arm
Attach the decorative cover by following step 10 of the "Wire
through a hole in the ceiling" section (☞ pages 22-23).
Wire through the wiring hole of the decorative cover.
• Wire through the opened area of the cutout part of
• Make sure that no cable is pinched by the decorative
Step 1
Step 2
the decorative cover.
[When pulling out from the side]
IMPORTANT:
cover.
23
Advertisement
Table of Contents
