Table of Contents
Advertisement
Available languages
Available languages
SHOT OF STEAM
If you intend to use steam the temperature control must be at ~or higher.
1.
Lift the iron off the fabric.
Press the ~ button.
2.
3.
Leave 4 seconds between shots, to let the temperature build up.
DRY IRONING
If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid spontaneous
bursts of steam.
1.
Set the steam control to S.
2.
Wait till the light goes off, then start ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•
Check that there's adequate ventilation behind the fabric, otherwise moisture may build up, causing
mildew.
•
Check that there's nothing behind the fabric that may be damaged by the steam.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Check that there's water in the reservoir.
1.
Set the temperature control to max. Set the steam control to S.
2.
Hold the iron close to (but not touching) the fabric.
Press the ~ button (you're using the "shot of steam" function vertically).
3.
4.
Leave 4 seconds between shots, to let the temperature build up.
AUTO SHUT-OFF
If the iron is motionless, it will switch off after about 30 seconds lying down, or about 8 minutes if it's
upright.
The iron will beep and the light will flash continuously until you move the iron.
To switch on again, lift it up, tilt it forward, then sit it upright to return to operating temperature. No
settings are lost during auto shut-off.
AFTER USE
1.
Set the temperature control to •. Set the steam control to S.
2.
Unplug the iron.
3.
Open the cover.
4.
Hold it over a sink, turn it upside down, and drain the water from the reservoir, via the water inlet.
5.
Close the cover.
6.
Sit the iron on its heel.
7.
Leave it to cool down completely.
8.
When it's cold, wipe off any moisture, and wind the cable round the heel.
9.
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
SELF CLEAN
To avoid scale build up, use the self clean function at least monthly in normal water areas, more often in
hard water areas.
Products returned under guarantee with faults due to scale will be subject to a repair charge.
You'll need a basin or a large bowl to catch the water coming out of the soleplate.
1.
Fill the reservoir to the max mark.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
UA
AE
Advertisement
Table of Contents
