Dell OptiPlex 5400 Service Manual page 79
Hide thumbs
Also See for OptiPlex 5400:
- Service manual (140 pages) ,
- Setup and speci?cations manual (42 pages) ,
- Setup and specifications (32 pages)
Table of Contents
Advertisement
Steps
1. Align the screw holes on the side I/O-board with the screw holes on the display-assembly base.
2. Replace the two screws (M2.5x3.5) to secure the side I/O-board to the display-assembly base.
3. Route the SIO-signal cable, SIO-power cable, and audio-board cable through the routing guides on the display-assembly
base.
4. Connect the SIO-signal cable, SIO-power cable, and audio-board cable to the connectors on the system board.
5. Align the screw holes on the side I/O-board shield with the screw holes on the display-assembly base.
6. Replace the two screws (M3x5) to secure the side I/O-board shield to the display-assembly base.
Next steps
1. Install the
rear-I/O
bracket.
2. Install the
bottom
cover.
3. Install the
system-board
4. Install the
back
cover.
5. Install the
cable cover
6. Install the stand.
7. Follow the procedure in
shield.
(optional).
After working inside your
computer.
Removing and installing components
79
Advertisement
Table of Contents
