Table of Contents
Advertisement
Ordering Additional Keys
The following steps are required if you need new keys (e.g. for new members of staff):
Keys with a security card
Send your order to the manufacturer together with the security card so that the new keys can
be registered on the card.
When you have received the additional keys, read them in as described in the chapter "Read-
ing In Keys and Programming the System". You do not have to re-read in the security card (or
customer card).
Standard key (without security card)
Order additional standard keys.
When you have received the key, read the standard key into the system as an additional key
(see chapter "Reading In Keys and Programming the System").
Restoring the Default Settings
Restore the default settings as follows:
1. The system is in a disarmed state (e.g. in revision mode).
!
2.
Remove the control unit cover. The plugs with the
LSN lines (3.4 and 7.8) must be removed from the control unit.
3. In the control unit, move the jumper from BR1 to BR2.
4. Close the tamper contact GK for at least 3 seconds until the yellow LED on the control unit is
deactivated and the buzzer emits a signal.
All the keys and the customer code have now been erased.
The default settings have been restored.
5. In the control unit, move the jumper from BR2 back to BR1.
6. Reconnect the plugs with the LSN lines to the control unit and reset the LSN line malfunction
message on the control panel.
Notes for Maintenance and Service
25
Advertisement
Table of Contents
