Manual Mode - England's Stove Works 55-TRPCB120 Installation & Operation Manual

The stove will heat to whichever temperature you set the stove at until the call for heat leaves, at which point
the stove will adjust itself higher or lower as needed, depending on the room temperature readings supplied by
the room heat sensor.
To turn the stove off completely, press the OFF button on the control board.
Manual Mode
Your stove can be changed to run in manual mode, if desired. In manual mode, after pressing the ON button,
the stove will run continuously, based on desired heat range and blower speed settings. The heat range settings
will be 1 through 9 (the Up arrow will increase the heat range and the Down arrow will decrease the heat range),
with 1 being the lowest auger feed setting and 9 being the highest. The blower speed range will match the heat
range that you have set.
Since the stove runs continuously at the selected heat range in this mode, it is generally recommended for
stoves installed in less‐insulated areas of the home and extremely cold climate regions.
To turn the stove off completely, press the OFF button on the control board.
Setting Stove in Manual Mode
o To set the stove in Manual Mode: With the stove plugged in press the down arrow and the up
arrow button simultaneously. This will toggle your stove to Manual Mode.
o While in Manual Mode, the stove board will display M1 (the lowest setting) and can be
adjusted with the up and down arrows.
Setting Stove in Automatic Mode
o To set the stove back into automatic mode, press the down arrow and the up arrow button
simultaneously. This will toggle the stove to Automatic Mode.
o While in Automatic Mode, the stove board will display the Set Temperature.
o The control board on this stove allows the user to adjust the heat output and convection
blower speed, turn the unit on and off, and test components for function (more on diagnostic
mode later).
This unit is meant to operate only with door closed. Smoke spillage and an inefficient, lazy
burn will result from attempting to operate the stove with the door open.
In addition, using fuel other than wood pellets can create an unsafe situation and can also
generate excess carbon monoxide. Carbon monoxide is an odorless, colorless gas which can
The use of a carbon monoxide detector is strongly recommended
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
be deadly. Be sure to burn only wood pellets.
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
CAUTION
21
.