Canon MP27-MG - Printing Calculator Manual

BEFORE STARTING

1. Remove the insulation tape at the back of calculator. (Figure )
   
   
2. Remove the tape on the ink ribbon of calculator. (Figure )
   
   
3. Plug in AC power cord. (Figure )
   
   
4. Turn the power switch on. (Figure )
   
   
5. Press [RESET] key before use. (Figure )
   

INSTALLING PRINTING PAPER

Note : Turn the power off

1. Remove the printer cover (Figure ) and lift up the paper arm (Figure ).
   
   
2. Replace the printer cover (Figure ).
   
   
   • When inserting the paper, cut the edge of the paper as shown (Figure ).
     
     
3. Turn the power switch on (Figure ).
   
   
4. Place the new paper roll on the arm. The edge of the paper should be positioned as shown (Figure ).
   
   
   • Suitable paper roll -- Width: 57mm (2-1/4") / Diameter: 86mm (3-3/8")
5. Press the paper feed key to advance the paper (Figure ).
   

REPLACING THE INK RIBBON

Note: Turn the power off.

1. Remove the cover and lift up the paper arm.
2. Lift ribbon spools off the shafts. Discard the old ribbon and spools.
3. Place the ribbon spool on the left spool pin and push it down until it clicks.
4. Thread the ribbon along the outer edge of the side guide, making sure that the black half of the ribbon is still on the top.
5. Place the ribbon between the printing ring and printing roller. Thread the ribbon along the outer edge of the left side guide.
6. Place the other ribbon spool on another spool pin.
7. Push the spool down until it clicks.
8. Take up any ribbon slack by rotating the left spool counterclockwise.
9. Replace the printer cover.

Use only the same type of ribbon spools.

REPLACING BACKUP BATTERY

Memory backup battery retains the tax rate, calendar and clock setting, when the power is off or even when the AC cord is disconnected.
Battery: 1 Lithium battery (Type: CR2032)
Battery life: Backup time 2000 hours

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instruction.

DECIMAL POINT SELECTOR SWITCH

	Used for designating the decimal point position (+ 0 2 3 4 6 F) for calculated results.
	+ (Add-Mode) – Addition and subtraction functions are performed with an automatic 2-digit decimal. It is convenient for currency calculations.
	F (Floating Decimal Point) – All effective numbers up to 12 digits are printed or displayed.

ROUNDING SWITCH

Used for round-up [], round-off [5/4], or round-down [] to the pre-selected decimal digits in the result.

GRAND TOTAL / RATE SET SWITCH

GRAND TOTAL

When the calculations are performed with the GT switch set to "ON", the total(s) are accumulated in the grand total memory. Each time is pressed, the subtotal number is printed with the symbols G+. When is pressed, the intermediate grand total is printed with the symbols G. Press successively to get the grand total followed by the symbols G.

TAX RATE SET

Set switch to "TAX RATE SET" for setting or recalling the TAX rate.

ITEM COUNT SWITCH

At "n+" or "n+/–" position, the calculator counts and print the number of calculation items up to 999. <ITEM COUNT> When the "ITEM" switch is set at "n+", the calculator counts the number of times the and keys are pressed. When the switch is set at "n+/–", the calculator counts the number of times the key is pressed and subtracts from the total numbers of times the key is pressed. <MEMORY ITEM COUNT> When the "ITEM" switch is set at "n+", the calculator counts number of times and keys are pressed. When the switch is set at "n+/–", the calculator counts the number of times the key is pressed and subtracts from the total number of times the is pressed. <PRINTOUT OF ITEM COUNT> When the PRINT switch is turned "ON", and the "ITEM" switch is at the "n+" or "n+/–" position, the number of items recorded by the counter can print up to three digits on the left-hand side of the paper by pressing either the key or the key for item count and key or key for memory item count.

PRINT ON/OFF SWITCH

	Print Off – Entries and results will appear on the display, but will not be printed out.
	Print On – Entries and results will appear on the display and will be printed out.

AUTO POWER SAVE

When the power is turned "ON" and the calculator is not being used for approx. 7 minutes. The calculator will switch to power save mode automatically with orange LED light-up. Press key the calculator will return to normal calculation mode.

OVERFLOW

In the following cases, when "E" is displayed, "ERR" is printed, the keyboard is electronically locked, and further operation is impossible.
Press to clear the overflow. The overflow occurs when:

1. The result or the memory content exceeds 12 digits to the left of the decimal point.
2. Dividing by "0".
3. The sequential operation speed is faster than the calculation processing speed.
   (Buffer Register Overflow)

• Electromagnetic interference or electrostatic discharge may cause the display to malfunction or the memory, currency rate and tax rate to be lost or altered. Should this occur, use the tip of a ballpoint pen (or similar sharp object) to press the [RESET] button on the back of the calculator. After resetting be sure to set the calendar, clock and tax rate again.
  

SPECIFICATION

Power Source: AC120V, 60Hz
Operation Temperature: 0°C to 40°C (32°F to 104°F)
Calculating Capacity: 12 digits maximum
Dimension: 320mm (L) x 193 mm (W) x 71mm (H) / 12-39/64" (L) x 7-39/64" (W) x 2-51/64" (H)
Weight: 1,812 g (4 lbs)
(Subject to change without notice)

• The socket-outlet shall be installed near the equipment and shall be easily accessible.

For CA, USA Only
Included battery contains perchlorate material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ for detail.
The bottom case and printer cover in this product are made from recycled Canon copier plastic.

CLOCK & CALENDAR FUNCTION

SETTING / AJUSTE:

	Used to switch between clock or calendar mode.
	Used to switch between 12 or 24 hour at clock mode time setting.
	Used to set the date and time in calendar & clock mode.
	Used to switch between AM or PM at clock mode time setting.
	Used to select date format between "YYYY/MM/DD", "DD/MM/YYYY" or "MM/DD/YYYY" at calendar mode.

Date setting
Example: November 17 2010

Time setting
Example: 3: 18 pm

MEMORY CALCULATION

DATA PRINTOUT

GRAND TOTAL CALCULATION

ITEM COUNT

PERCENTAGE CALCULATION

TIME CALCULATION

	Used to calculate the amount of time or duration of activities, such as wages hours and cost estimation.
	Used to switch between 12 or 24 hour in the time calculation mode.
	Used to switch between AM or PM in the time calculation mode.

Example 1:
Calculating wages for a part-time job: 10:30 to 22:15, US$7 per hour

Example2:
Calculating wages for a part-time job: 8:30 to 11:45 am plus 1:00 to 5:30 pm, 20days per month, US$9 per hour

Example 3:
Calculating wages for a part-time: 4:15 hours (In morning) plus 3:30 hours (In afternoon), US$12 per hour

• ** Minutes input value: 0 to 59. Values greater than 59 are automatically adjusted by adding to the hour(s).
• ** Calculation range: –99 hours 59 minutes to 99 hours 59 minutes. If the input/output value out of the allowable range, the time calculation will overflow.

TAX CALCULATION FUNCTION

	Add Tax Key – Used for adding the tax amount to the displayed figure.
	Deduct Tax Key – Used for deducting the tax amount from the displayed figure.

COST-SELL-MARGIN CALCULATION

Used for calculating the cost, selling price and profit margin amount. Enter the value of any 2 items to obtain the balance value item. (e.g. enter the value of the cost and the selling price to obtain the profit margin %.)

OVERFLOW

CANON ELECTRONIC BUSINESS MACHINES (H.K.) CO., LTD.
17/F., Ever Gain Plaza, Tower One, 82-100 Container Port Road, Kwai Chung, New Territories, Hong Kong

CANON U.S.A., INC.
One Canon Plaza, Lake Success, NY 11042, U.S.A.

CANON CANADA INC.
6390 Dixie Road, Mississauga, Ontario, L5T 1P7, Canada

CANON LATIN AMERICA, INC.
703 Waterford Way, Suite 400, Miami, FL 33126, U.S.A.