Pyle PWD250 System Manual page 18

Remote Start Programmable Features
1. Engine Run Time. Selects between 10, 15,
20, and 30 minute run cycles.
2. Turbo Timer Feature. For vehicles equipped
with a turbocharger, this feature allows the
engine to continue running for up to 6 minutes
after the ignition is turned off, so the turbo has
time to cool down.
3. Cold Temperature Starting. Allows the
vehicle to automatically start and run every 1,
2, 4, or 12 hours for severe cold weather.
4. Manual Transmission
between Quick Set and Safe operating modes.
On manual transmission vehicles, the remote
start feature will not operate unless the proper
vehicle exit sequence is performed. These two
modes protect against in-gear starting but are
not completely without risk. Installation and
safe use of the remote start feature on a
manual transmission vehicle is the sole risk of
the vehicle's owner, and the manufacturer
assumes no liability for use in manual
transmission vehicles.
Manual Transmission Quick Set Mode Exit
Sequence: Turn the ignition off and the engine
will remain running. Exit the vehicle. When all
doors are closed, press lock button to turn off
engine and arm/lock doors. The system will be
able to remote start as long as the alarm is not
disarmed prior to remote starting.
REMOTE START PROGRAMMABLE FEATURES
Step Function
1. Engine Run Time
2. Turbo Timer Mode
3. Cold Start Timer
4. Manual Transmission Mode
5. Parking Light w/Start
6. Lock on Remote Start
7. Lock on End Start Cycle
8. Yellow/Black Wire Program Factory Disarm
9. Diesel Wait-to-Start Mode
Manual Transmission Safe Mode Exit Sequence:
With ignition on, press lock button for two
seconds (button mode shifts to level 2) the
press lock button again. Turn ignition off
(engine will stay running) and exit vehicle.
When all doors are closed, press lock button to
turn off engine and arm/lock doors. The system
will be able to remote start as long as the alarm
is not disarmed prior to remote starting.
5. Parking Light Mode. Selects the operation
of the parking light output while the vehicle is
remote started. Choose between flashing
Mode. Selects
output, constant output, and off.
6. Lock with Remote Start. Automatically
locks the doors after remote starting.
7. Lock with Remote Shutdown.
matically locks the doors 5 seconds after the
remote start is shut down.
8. Yellow/Black Wire Programming. Selects
between Factory Disarm, 3rd ignition (relay
required), and Pulsed or Latched Defroster
output. When set for Factory Disarm output,
the Yellow/Black wire pulses on disarm and
remote start to turn off a factory alarm. When
set for 3rd Ignition output, the wire turns on
with Ignition 1 and 2 relays. When set to Pulsed
Defroster output, the wire pulses 10 seconds
after remote starting. When set to Latched
Defroster, the wire turns on 10 seconds after
remote starting and remains on for 5 minutes.
Button 1 Button 2
10 minutes 15 minutes
Off I minute
1 hour 2 hours
Quick set Safe
Flashing Continuous
No lock Lock
No Lock Lock
Ignition 3 output Defroster pulse
10 second timer Glow Plug Input
18
Button 3 Button 4
20 minutes 30 minutes
3 minutes 6 minutes
4 hours 12 hours
Off
Defroster latch
Auto-