Entering Programming - Pyle PWD202 User Manual

500mA. Connect to an optional relay to activate
the vehicle's horn when the alarm is triggered.
• BLACK/WHITE WIRE - Dome Light output
(-) 500mA. Connect to an optional relay to
activate the vehicle's dome light.
• ORANGE WIRE - Armed Output (-) 500mA.
The ORANGE wire provides a ground when
the unit is armed to activate a circuit disable
relay or other device (i.e. window control
module, etc.).
• GRAY WIRE - Auxiliary output (-) 500mA.
Connect to a relay for an optional feature such
as trunk release, etc.
• WHITE WIRE - Parking Light output (+/-)
10A relay. Connect to the vehicle's parking light
wire. If the vehicle's parking light circuit exceeds
10 amps a relay is required. For vehicles with
independent left and right parking light circuits,
the parking light wires must be connected using
diodes to keep the circuits separate. Make sure
to set the proper polarity for the internal relay
jumper before connecting the main harness.
NOTE: Do not connect the WHITE wire to the
vehicle's headlight circuit.
Starter Defeat Connectors
Using a volt/ohm meter locate the starter wire
(normally a heavier gauge wire) at the ignition
switch. This wire will show +12V only during
cranking. When this wire is cut the vehicle will
be unable to start. Cut the BROWN starter
disable wire (with the two female connectors),
and connect one side to the vehicle's starter
wire coming from the key switch. Connect the
other BROWN wire to the wire going to the
starter. Plug the female connectors on the
BROWN wires to the .250 male spade lugs on
the module. With the BROWN wires
connected to the module, the vehicle should be
able to start.
Plug in Connectors
3-Pin White Door Lock Connector: Plug-in
connector port for door lock harness or
optional door lock relay module.
• BLUE WIRE - unlock output (-) 500mA.
• RED WIRE - +12V output (+) 300mA for relay
modules, or inverters. Do NOT use as a power
source for door lock relays.
• GREEN WIRE - lock output (-) 500mA.
2-Pin Red Connector: Plug-in connector port
for LED. Mount LED in an area where it may be
easily seen from either side of the vehicle.
2-Pin Blue Connector: Plug-in connector port
for valet switch. Mount switch in an area that is
easily accessible from the driver's seat.
4-Pin White Connector: Plug-in connector
port for dual stage shock sensor.

Entering Programming

To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5 times.
• The siren will emit a long chirp, to
indicate entering program mode.
3. Press the valet switch the number times
equal to the desired feature.
• The siren will chirp each time the valet
switch is pressed. A long chirp is equal to
5 presses. (Example: step 7 = 1 long chirp
and 2 short chirps.)
4. Within 5 seconds, press the transmitter
button corresponding to the desired
operating mode for that feature.
• The siren will chirp to indicate the setting.
One chirp = Button 1
Two chirps = Button 2
Three chirps = Button 3
5. Turn off ignition to save changes.
5