Wired Network - Freeview (Network Port Is Only For Uk Models) - Philips 24PHS4304 User Manual

Before you can pause or record a broadcast, you
must connect and format a USB Hard Drive.
Formatting removes all files from the USB Hard Drive.
Warning
The USB Hard Drive is formatted exclusively for this
TV, you cannot use the stored recordings on another
TV or PC. Do not copy or change recording files on
the USB Hard Drive with any PC application. This will
corrupt your recordings. When you format another
USB Hard Drive, the content on the former will be lost.
A USB Hard Drive installed on your TV will need
reformatting for use with a computer.
5.9
Wired Network - Freeview
(Network port is only for UK
models)
Network
About Network
Network port and function is for Freeview HD
streaming features only.
Connect to Network
To connect the TV to the Internet, you need a
network router with a connection to the Internet.
Use a high-speed (broadband) connection to the
Internet.
Make the connection
To make a wired connection...
1. Connect the router to the TV with a network cable
(Ethernet cable**).
2. Make sure that the router is switched on.
3. Press  (Home) , select Settings > Network and
press  (right) to enter the menu.
4. Select Connect to network and press OK.
5. Select Wired and press OK. The TV constantly
searches for the network connection.
6. A message will be shown when the connection is
successful.
If the connection fails, you can check the DHCP
setting of the router. DHCP should be switched on.
Network Settings
 (Home) > Settings > Network > View network
settings
You can view all current network settings here. The IP
and MAC address, signal strength, speed, encryption
method, etc.
 (Home) > Settings > Network > Network
configuration
If you are an advanced user and want to install your
network with Static IP addressing, set the TV to Static
IP.
Select Static IP configuration and configure the
connection. You can set the number for IP
address, Netmask, Gateway, DNS.
16