AIMS PWRINV1800W Assembly And Operating Instructions Manual

AIMS PWRINV1800W Assembly And Operating Instructions Manual

Advertisement

Quick Links

AIMS POWER INVERTER
2,000 WATT / 4,000 WATT PEAK
PWRINV1800W
ASSEMBLY AND OPERATING INSTRUCTIONS
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWRINV1800W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AIMS PWRINV1800W

  • Page 1 AIMS POWER INVERTER 2,000 WATT / 4,000 WATT PEAK PWRINV1800W ASSEMBLY AND OPERATING INSTRUCTIONS TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE.
  • Page 2: Specifications

    Specifications Input Voltage s t l over voltage protection) s t l . y t 10.75”Lx9.25”x3.75” 8.38 n, Volt and Amp LED bar graph c t i ° c i t ; d 1 AWT (1 / 0) Save This Manual You will need the manual for the safety warnings and precautions, assem- bly instructions, operating and maintenance procedures, parts list and diagram.
  • Page 3 Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain. Keep work area well lit. Do not use electrically powered tools in the presence of flammable gases or liquids. Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools, or extension cords.
  • Page 4 Unpacking When unpacking, check to make sure that the Inverter is in good condition. If any parts are missing or broken, please call AIMS Power,Inc. at the number found on the warranty card.
  • Page 5 BACK Negative Ground Positive Connection For the power inverter to work properly, your power source must provide 12 volts DC, and the power source must provide enough current (i.e., 46 amps to operate the load of 560 Watts or under). Caution: This inverter must only be connected to batteries with a nominal output voltage of 12 volts.
  • Page 6: Operation

    FRONT Power Indicator Display Switch Outlets (covered) Remote Operation Warning: NEVER operate this inverter unless it is properly grounded. Open the rubber cover on the receptacle(s) and plug the 115 VAC device(s) you wish to power into the 3-prong AC Receptacles. See FRONT above. The appliance(s) must not use more than 2,000 (total) watts during continuous operation, otherwise it may overload the Inverter.
  • Page 7: Remote On/Off Switch

    This device does not contain any other user replaceable parts.If it needs service,contact your retailer or AIMS Power(see warranty page for details).
  • Page 8: Troubleshooting Tips

    Troubleshooting Tips If the low battery alarm sounds, this means that the input voltage is below the necessary 10.5 V. The battery needs recharging. You should stop using the appliance and then recharge the battery. If this is not done, the Inverter will shut off automatically at around 10 V.
  • Page 9 We will do our best to resolve your concerns. If the product needs repair or replacement, make sure to keep your receipt/invoice, as that will need to be sent back along with the package and RA# prepaid to AIMS. You have a full 1 year from date of purchase warranty.

Table of Contents