BorMann BWR5044 Manual page 6

EN
10. Fastening the bicycle(s) to the holders
•
•
•
•
Suggested method for
securing the handlebar
and pedals.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes
significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands
may also concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious
injury or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
6
Make sure that the remaining straps remain tight and in place after you
have finished installing them.
Place the bicycle on the carrier in to the bicycle holders.
Make sure that the peddles or handlebars will not scratch the rear of the
vehicle. The tyres must be put at least 30cm away from the exhaust tailpipe.
Use the other straps to fix the bicycle to the holders.
Retighten the straps and tighten the adjusting knobs (they may have come
loose after the weight of the bicycle(s) has been placed on the carrier).
WWW.NIKOLAOUTOOLS.GR