Installation - BorMann BWR5044 Manual

EN
Before installation, make sure that the packaging includes the following parts.
1 x bike carrier frame including pre-attached 6 bike
frame clamps
2 x 40x6mm bolts
2 x Μ6 nylock lock nuts
2 x 13mm Μ6 washers
4 x steel anchor loops
4 x plastic strap buckles
2 x 1190mm straps with plastic-coated fitting hook
4 x 930mm straps with plastic-coated fitting hook
6 x 700x10mm bike frame retaining straps
1. Preparation
• Before installing the bike rack, clean all surfaces of your
car that will come into contact with the straps or the
carrier frame.

2. Installation

• Remove the carrier frame as well as all other
components.
• Place the carrier frame as shown in the photos
according to the type of your car.
• Unscrew the locking mechanism located on the
carrier frame to adjust the carrier to the correct
position.
3. Instructions for use
3
Always use the straps to secure the bikes.
•
• Take care during installation that the exhaust tailpipe of the car
will not be too close to the tyres of the bicycle.
The weight of the bicycles can cause the straps to loosen, so prior to
•
taking the vehicle onto the road check that all straps are in place and
sufficiently tightened.
• It is necessary to check that all straps are sufficiently tightened on a
regular basis. It is also important that you check the carrier after driving
over rough or uneven surfaces. If you notice that the carrier or bicycle has
moved then stop the vehicle in a safe position and check the bike rack.
WWW.NIKOLAOUTOOLS.GR
Fitting the frame straps
Unscrewing one of the Clean the vehicle prior
locking mechanisms to fitting the strap hooks