BorMann BWR5044 Manual page 4

EN
4. Fitting the lower strap anchor points
•
•
•
5. Adjustment
•
Feeding the top straps through the spring locking clasp
6. Attachment of straps
•
4
Select the 40x5mm bolts and pass the steel anchor hooks through the
plastic belt clips. Pass the bolt with the steel anchor hook through the hole
in the bottom of the carrier frame.
Place another steel anchor loop onto the end of the protruding bolt followed
by one of the steel washers. Finger tighten the M5 nylock nut.
Tighten using two 10mm spanners (not supplied), making sure not to
overtighten so as to allow a little movement for adjustment.
Turn/unscrew the locking mechanisms' knobs located on the carrier frame
to adjust the carrier so that there is at least a 20-degrees angle facing
upwards (as shown). Tighten the locking mechanisms until secure.
Unscrewing one of the
locking mechanisms
Once the carrier frame is in the correct position, take the two 1190 straps
with plastic coated fitting hooks and four 930mm straps with plastic coated
fitting hooks that are to be placed in each of the fasteners. To fasten, adjust
the straps to the correct length and at the same time push the safety
button to fasten the belt. Make sure that the belts are securely fastened.
WWW.NIKOLAOUTOOLS.GR
20 degrees