Table of Contents
Advertisement
Search for a Location
Address Actions
When you have specified an address, tap the Actions button to select from the following commands:
Set as Origin
Show on Map
Add to My
Favorites
Information
Go to your Destination
After you have specified the address, tap the Next button. Destinator shows your destination on the Map
screen before calculating a route. Check that the destination address is correct at the top of the screen. If
you want to change the destination, tap the Back button and change your address entries.
1.
2.
Figure 10 - Calculate your Destination
Destinator User Manual
Lets you designate the selected address as the route origin. Use this
command when calculating a route from a point other than your current
location. The navigation device displays the selected location as a starting
point only for a few seconds before returning you to your current location.
Note: You are still receiving the GPS signal.
Lets you see the selected address on the map.
Lets you add an address to your list of favorite locations, as shown in the
figure below. For more information, see "My Favorites" on page 20.
Figure 9 - Add Address to My Favorites
Displays the location's address information.
13
Advertisement
Table of Contents
