SAFETY INSTRUCTIONS Please read this section carefully and follow all the instructions given. This will help ensure reliable operation and extend the service life for your appliance. • Keep the packaging and the user instructions for future reference or inquiries. 1) Never open up the housing of the appliance, it contain no user-serviceable parts.
Page 3
SAFETY INSTRUCTIONS • Arrange cables so that no-one can tread on them or trip over them. Do not place any items on the cable. • Working with memory card This navigation system supports SD memory cards. 1)Inserting memory cards: Carefully take the memory card out of its packing (if included). Take care not to touch or dirty the contacts.
INSTALLATION • Mounting The Navigation Set In A Car Use 4 screws ( 5X25) to install the navigation set to the car, please refer to the followed diagram.
Page 5
ACCESSORIES • GPS BOX • GPS ANTENNA • REMOTE SENSOR • RGB TO RGB CABLE • RGB TO RCA VIDEO LINEOUT • SD CARD • REMOTE CONTROL • SCREW 5X25 (4 PCS)
Page 6
GPS BOX One Side Other Side 1. GPS ANT (GPS Antenna, To receive GPS signal.) 2. Socket (Connect GPS Box And The Unit) 3. RGB/VIDEO Switch (Switch between RGB mode and VIDEO mode.) 4. RESET (Reset Button) 5. PWR (Power Indicator LED) 6.
REMOTE CONTROL 1. ESC Press it to exit the current menu. (ENTER) Press it to enter the selected item. These buttons serves as navigation-pad, moves up / down / left / right by pushing the corresponding area of the pad. 4.
OPERATION • Console When all the connections is finished, turn the unit on, switch the mode to navigation mode, the unit will enter the following interface automatically. Note: If you have set “Auto navigation when power on”, when you turn on the unit, it will skip Console interface and enter navigation interface automatically.
Page 10
OPERATION 6)Tap to enter volume option menu. There are two method to adjust the volume: Method A: When you select , press OK button on remote control to adjust the system volume level. Method B: When you select press / (Left/Right) buttons on remote control to adjust the volume up or down.
SOFTWARE OPERATION 1) When all the connections is finished, turn the unit on, switch the mode to navigation mode, the unit will enter the following interface automatically. Note: If you have set “Auto navigation when power on”, when you turn on the unit, it will skip Console interface and enter navigation interface automatically.
Page 12
SOFTWARE OPERATION When the installation is finished it will return to Console interface automatically. 5) Tap icon to enter Setting menu, then in Setting menu to enter Navi Option menu: to enter Device menu: Double tap NANDFlash folder to open it : Double tap Destinator folder to enter it and select Dextinator.exe, then tap...