Table of Contents
Advertisement
Search for a Location
Search Near a Location
You can tap the Near button to determine the location area, where you want to search for a specific place,
such as a petrol station, hotel, or restaurant.
The available options are listed below.
Current Location
Destination
Other Address
Search Radius
Show or Hide Symbol on Map
You can add or remove the ticks next to a POI entry to show or hide the POI symbol on the Map.
POI Actions
When you have selected a POI location, tap the Actions button to display the commands listed below.
Set as Origin
Show on Map
Add to My Favourites
Sort By ABC or
Distance
Send SMS
Information
User's Guide Destinator
Lets you search near your current location. This is the default value.
Lets you search near a specified destination. For example, you know your
general destination, but not very much about interesting locations in the area.
You can use Destinator to locate the tourist attractions close to your
destination. Note that this button is enabled only when a destination is
entered.
Lets you search near another address. For example, you have set a
destination, but on the way you want to stop at another location. You can use
this feature to search near that location for restaurants, lodging, historical
sites, or other locations.
Enter the location distance to search for a designated place. For example, if
you enter 5 km, Destinator only searches within a five kilometre radius.
When you select a large search radius, you risk the chance of finding too
many locations, which makes it harder to find the place that you are searching
for. It is best to start with a small search radius size, and then increase the
radius size if necessary.
Note: if you don't specify a search radius, Destinator searches the whole
map and displays the locations according to the distance from you.
Lets you designate the selected location as the route origin. You would use this
command when calculating a route from a point other than your current location.
Tap the Free Map Browsing button to disconnect from the GPS receiver.
Lets you see the selected address on the map.
Lets you add an address to your list of favourite locations, as shown in the figure
below. For more information, see "My Favourites".
Lets you sort the entries of the selected category alphabetically or by distance from
your current location.
Note: Destinator initially displays the entries by distance.
If you are using a phone-enabled navigation device, you can send your current
location in an SMS message. For more information, see "Sending an SMS
Address (on page 33)".
This button displays the location's address information.
19
Advertisement
Table of Contents
