Table of Contents
Advertisement
6
WARNING
USE SEAT BELTS WHILE THE VEHICLE
IS IN MOTION. DO NOT OCCUpy SEATS
THAT ARE NOT EQUIPPEDWITH BELTS.
READY TO LEAVE
BE SURE TO PLACE THE ENTRY STEP IN TRAVEL
POSITION.
STARTING AND WARMUP
Follow the recommendations in your Chassis Operator's
Manual when starting or operating your engine.
NOTE:
Be sure transmission is in "P" park and parking brake
is engaged to keep the motor home from rolling. If th
parking brake needs adjustment, see the Chassis
Operator's Manual for adjustment instructions.
SAFETY BELTS
Seat belts are an important safety feature of your vehicle ..
Belts should be fastened while your motor home is in motion.
The driver's seat and all other seats designed to carry passengers
while under way have been equipped with lap belts.
All riders should be furnished with and use seat belts
while the vehicle is in motion. Seats which are not
equipped with safety belts should not be occupied
while vehicle is in motion and will be labeled: "THIS
SEAT NOTTO BE OCCUPIED WHILE VEHICLE IS
IN MOTION."
PASSENGERS SHOULD NOT BE ALLOWED TO
RIDE IN THE CAB·OVER BED AREA.
Safety belts are adjusted in' the following manner: To lengthen
the belt, tip the buckle at right angles to the belt. Holding the
buckle in this position permits the belt to slide through. Pull on
the buckle until the desired length is obtained. To fasten the
belts, make sure the belts are not twisted, then push the tongue
end of one belt into the bUCKle of the mating belt. Be sure it go·
in all the way and that it latches. Tighten by pulling the loose
end of the belt while holding the buckle. Adjust the belt
as Iowan the abdomen and as snug as comfort will allow for
greatest safety. Never use a belt for more than one person at
a time.
NOTE:
If your belts have been equipped with retractors, be
sure belt is pulled all the way out of retractor.
To release the belt, depress the button in the center of the buck
and slide the tongue out of the buckle.
Advertisement
Table of Contents
