Husky F226VWD Operator's Manual page 14

WARNING
Always disconnect the air supply and power supply
before making adjustments, servicing a tool, or when a
tool is not in use.
DRAINING THE TANK
See Figure 6-1, 6-2.
To help prevent tank corrosion and keep moisture out of the air
used, the tank of the compressor should be drained daily.
To drain:
g Turn the air compressor off.
g Pull the ring on the pressure relief valve to release until
pressure gauge reads less than 20 psi.
g Release the ring.
g Open the drain valve allowing air to bleed from the
tank. (6-1)
g Tilt tank as shown in figure 8 to drain moisture from tank
into a suitable container.
NOTE: Condensate is a polluting material and should be
disposed of in compliance with local regulations.
g If drain valve is clogged, release all air pressure, remove
and clean valve, then reinstall.
WARNING
Unplug the air compressor and release all air from the
tank before servicing. Failure to depressurize tank before
attempting to remove valve may cause serious personal
injury.
g Close the drain valve. (6-2)
OPERATION
Figure 6-1
Page 12
Figure 6-2