Advertisement
The tongue is designed to adjust from left to right within the hitch pivot. This allows the mowers
position to be varied behind the tow vehicle. This is accomplished by pulling the 5/16" wire lock
pins out and choosing two other hole locations on the tongue. See Figure 3.
B. ADJUSTING CUTTING HEIGHT
Shut off the engine and allow the mower blades to come to a complete stop before
adjusting the cutting height.
Mower Blade
Lower Edge of
Deck
Smooth Surface
Directly Behind
Figure 4: Rough Cut Tow Behind Towing Suggestions
Figure 5: Adjusting Rough Cut Mower Cutting Height
Measure This Distance
and Add 1-5/16" to get
Cutting Height
4
Offset
Adjustment Crank: Roughly 6
turns equals 1.0"
Cutting Height
1-5/16"
Advertisement
