Table of Contents
Advertisement
18
Medalist Pro 2160sl and 2520sl, Rev. B
Additional installation options
Figure 5. Remote LED connection and cable select jumper
Remote LED connection
If you want to connect the drive to a remote LED that indicates
drive activity, attach the LED connector to pins 1 and 2, as
shown in Figure 5. The red wire to the LED (+) should attach to
pin 2 on the drive. The LED must have a 0.1-inch-wide connector
to fit on these pins. Do not install a jumper on these pins.
2 4 6
8
Pin 1
1 3 5
7
Enable Cable Select
Remote LED connection
Advertisement
Table of Contents
