Advertisement
DISPOSABLE BAG CHANGING:
The recommended bag replacement procedure is as follows:
1. Remove can cap from unit.
2. Tape a 6-mil poly bag over the can cap so that the paper bag is
completely enclosed.
3. Using the poly bag as a glove, disengage the paper bag from the
can cap's vacuum inlet stem.
4. Seal the poly bag and dispose as prescribed by law.
5. Attach a new paper bag securely to the vacuum inlet and fold the
bottom of the bag lengthwise.
6. Replace the can cap and close the clamps.
7. Thoroughly vacuum the work area to recover any asbestos dust
which may have been dropped.
GASKET REPLACEMENT:
If the air seal gasket is cut or otherwise damaged resulting in an air
leakage, simply remove it from the filter flange and replace it with a
new gasket.
Symptom
Loss of Suction
Motor Won't Run
WARNING : Always disconnect power cable from electrical outlet when working on this machine.
ABOUT THE VACUUM
TROUBLE SHOOTING GUIDE
Possible Cause(s)
1) Obstruction in hose or wand
2) Clogged air filter assembly
3) Uneven gasket fit
4) Dented canister rim
1) Blown fuse or tripped circuit
2) Defective cordset
10702 N 46th Street • Tampa, FL 33617
(813)971-2223 • toll free (800) 237-7582
fax (813) 971-6090 • order entry fax (800) 833-8875
To effectively control asbestos dust emissions from
the vacuum cleaner, All filters must be in place at all
times. If any visible dust emissions are observed in
the vacuum exhaust air stream, stop operations
immediately. If this occurs, the HEPA filter has rup-
tured or must be replaced.
Corrective Action
1)
Clear hose
2)
Brush Moleskin filter, replace primary filter
3)
Reposition or replace gasket
4)
Replace canister
1)
Replace fuse or reset circuit
2)
Replace cordset
www.pullmanholtcorp. com
WARNING
B700006 1/04
Advertisement
