Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel; Cleaning The Infuser; Cleaning The Milk Container - DeLonghi Eletta Cappuccino Evo Instructions For Use Manual

3. Replace the filter (if installed), fill the tank (A14) with fresh
water and replace;
4. (Models with water softener filter only) Deliver 100ml of
water to reactivate the filter.

11.7 Cleaning the coffee spouts

23

11.8 Cleaning the pre-ground coffee funnel

Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.

11.9 Cleaning the infuser

The infuser (A12) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
1. Make sure the machine has run the shutdown procedure
correctly (see "5. Turning the appliance off");
2. Remove the water tank (fig. 2).
3. Open the infuser door (fig. 24) on the right side of the
appliance.
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (fig. 25);
Important!
RINSE WITH WATER ONLY
NO DETERGENTS - NO DISH WASHER
1. Clean the coffee spouts
(A9) regularly with a
sponge or cloth (fig. 23);
2. Check the holes in the
coffee spouts are not
blocked. If necessary, re-
move coffee deposits with
a toothpick (fig. 23).
24
Do not use detergents to clean the infuser as this could cause
damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 26), then push the PUSH symbol fully
in until it clicks into place.
Please note:

11.10 Cleaning the milk container

To keep the frother efficient, clean the milk container as de-
scribed below, every two days:
1. Remove the lid (D2).
25
2. Remove the milk spout (D3) and intake tube (D4) (fig. 29).
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 29) and pull off upwards.
14
26
If the infuser is difficult to in-
sert, before insertion, adapt
it to the right size by pressing
the two levers shown in fig.
27.
8. Once inserted, make sure
the two red buttons have
snapped out (fig. 28).
9. Close the infuser door.
10. Put the water tank back.
28
27