Toyota Highlander Hybrid 2010 Manual page 248

Hide thumbs Also See for Highlander Hybrid 2010:
Table of Contents

Advertisement

2-5. Driving information
● When restarting after parking on a slope:
STEP
1
With the transmission in the P position, start the hybrid sys-
tem. Be sure to keep the brake pedal pressed.
STEP
2
Shift into D or the R position (if reversing).
STEP
3
Release the parking brake and brake pedal and slowly pull or
back away from the wheel blocks. Stop and apply the brakes.
STEP
4
Have someone retrieve the blocks.
Before towing
Check that the following conditions are met:
The vehicle's tires are properly inflated. (P. 549)
Trailer tires are inflated according to the trailer manufacturer's recom-
mendation.
All trailer lights work.
All lights work each time you connect them.
The vehicle remains level when a loaded or unloaded trailer is hitched.
Do not drive if the vehicle is not level, and check for improper tongue
load, overloading, worn suspension, or other possible causes.
The trailer cargo is securely loaded.
The rear view mirrors conform to all applicable federal, state/provincial or
local regulations. If they do not, install rear view mirrors appropriate for
towing purposes.
Break-in schedule
If your vehicle is new or equipped with any new power train components
(such as an engine, transmission, differential and wheel bearing), Toyota
recommends that you do not tow a trailer until it has been driven for over 500
miles (800 km).
However, avoid full throttle acceleration.
248

Advertisement

Table of Contents
loading

Table of Contents