SIT-INSIDE KAYAK ASSEMBLY • Slide the front tip of the cover down under the cover bracket (Fig. 1) of the kayak and set the cover down over the seat and onto the hull (Fig. 2 and Fig. 3). Cover bracket Cover Fig.
Page 5
SIT-INSIDE KAYAK ASSEMBLY • Bring the latches down over the catch brackets on the hull and pull up on the latches to lock the cover in place. Reverse the steps to remove the cover.
KAYAK TRANSPORT • Before transporting: crossbars, a roof rack or some other means of tethering your watercraft to your vehicle is necessary. Place foam pads or similar on the roof of your vehicle at least 32" apart or, if available, slip them over crossbars.
DRAINING WATER FROM THE KAYAK • When water gets inside the hull of the kayak: Remove the plug from the back of the kayak. Tip the kayak on its end and upside down to allow water to drain out of the hull.
Page 8
DRAINING WATER FROM THE KAYAK • When water gets in of the cockpit or on the rear of the hull: remove the two scupper plugs to allow it to drain. If necessay, keep them unplugged and continue paddling to allow the venturi on the bottom of the hull to remove the water.
PRIORto use. • Maximum occupancy 1 person • Maximum weight capacity 250 lb (≈114 kg) 1229838 MAINTENANCE Congratulations on your Lifetime ® watercraft purchase. By following the instructions below, your ® new Lifetime watercraft should provide you with years of service and enjoyment.
Please keep these documents in a safe, secure place. All warranty claims must fi rst be submitted in writing to Lifetime Products, Inc. PO Box 160010 Clearfi eld, UT 84016-0010 for determination of service or replacement of any defective watercraft hull.
Page 12
® ENHANCE YOUR LIFETIME WATERCRAFT BY ADDING ACCESSORIES OR OTHER GREAT PRODUCTS To purchase accessories or other Lifetime products, visit us at: www.lifetime.com Or dial 1-800-424-3865 www.lifetime.com 1229729 C 5/19/2023...
Need help?
Do you have a question about the emotion CABRIO 91136 and is the answer not in the manual?
Questions and answers