Conair TC700, TC701 - Pro Cordless Stylers Manual

HOW TO OPERATE YOUR CORDLESS THERMACELL CURLING IRON

1. Remove the protective cap from the cartridge. Keep the cap in a safe place so you can put it back on the cartridge for future storage. Push the 'OFF' button to make sure styler is off.
2. Insert the threaded end of the cartridge into the curling iron handle and slide it in until it stops, then screw cartridge in a clockwise direction until it is secure. MAKE SURE THE SWITCH IS OFF UNTIL YOU ARE READY TO USE THE IRON, OR YOU WILL WASTE BUTANE.
3. When you are ready to use the iron to style your hair, press the 'ON' button.
   Wait 5 seconds, then press the ignitor switch several times. You may hear a slight popping sound as iron starts. For curling iron only: look into the circular window lens at the end of the cool tip. If the iron is heating, a glowing wire will be visible. If not, press the ignitor switch a few more times.
   THE IRON WILL BE READY TO USE WITHIN TWO MINUTES. NEVER LEAVE THE IRON 'ON' AND UNATTENDED.
4. After you have finished styling your hair, please remember to press the 'OFF' button. Remove the cartridge from the iron and replace the cap. Do not store the cartridge in the iron.

CURLING BASICS

1. Section dry hair evenly and comb each section before winding. Pressing the automatic curl release, place curling iron midway up the hair section, then spread hair evenly between spoon and barrel. Release automatic curl release to hold hair in place and gently slide curling iron down to hair ends. To avoid crimped ends, make sure they are securely wound under the spoon in the direction of the desired curl.
2. Always place the spoon above the hair strand when rolling a curl under; place the spoon under the hair strand when making a flip style.
3. Wind hair up as far as you want it curled, being careful not to let the iron touch the scalp. Hold in place for 8 to 12 seconds, depending on the texture and length of your hair. For tighter, bouncier curls, roll less hair. For looser, free-flowing curls, roll more hair.
4. To remove iron, unwind the hair strand and press the automatic curl release. To set the curl, do not comb or brush hair until it cools. If you want a natural, ropey, 'beachy' new look, just finger-comb strands, first rubbing a tiny bit of gel on your fingertips.
5. After you have finished styling your hair, please remember to press the 'OFF' button to turn off the iron.

STRAIGHTENING BASICS

Start with a hair section that is 2 in. (5 cm) wide and no more than 1/2 in. (1.25 cm) thick. Open the iron and place a hair section between the two hot plates, close to the scalp. Trap hair between the plates and while maintaining tension, slowly pull the unit down along the hair section toward the end of hair. At the end of hair section, release the pressure on the handle and allow the hair section to slide out. Repeat process on additional sections of hair until you achieve the hair style you desire. It may be necessary to repeat process on certain areas, depending on the texture of your hair. Some experience is necessary when learning to use this straightening iron. After using iron several times, you will learn the ideal way to straighten and style your hair easily.
NOTE: Please refer to the temperature setting guide for heat settings.

GET TO KNOW YOUR CORDLESS IRONS

USER MAINTENANCE

Your appliance is virtually maintenance-free. No lubrication is needed. If cleaning becomes necessary, make sure the unit is off and the iron is cool. Wipe exterior with a cloth. If any abnormal condition occurs during use, turn off the iron, allow it to cool and return it for repair to an authorized service center only. No repairs should be attempted by the consumer.

STORAGE
When not in use, your styler is easy to store. Allow appliance to cool, then simply store out of reach of children in a safe, dry location.

To purchase cartidge refills visit www.conair.com or call 1-800-3-CONAIR. Ask for Model #TC2WBC or TC2RBC