Table of Contents
Advertisement
16 electrolux
1. Move the shelf holders in the direction of
the arrow (A).
2. Raise the shelf from the rear and push it
forward until it is freed (B).
3. Remove the retainers (C).
Rear spacers
Install the spacers provided within the ac-
cessory bag as shown in the figure.
When two appliances are placed beside
each other, attach the adhesive spacers be-
tween the appliances.
Install two spacers on the back side of the
panel and two spacers with adhesive on the
lower part.
Connecting the water hose.
Water supply should be provided with a tap
and 3/4" male connector within 1,5 m from
the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps and
tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
Before the refrigerator is placed its final loca-
tion, ensure that the water connection has
been correctly carried out, that there is no
leakage at the connection to the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly posi-
tioned in the connector.
We recommend that the appliance is placed
on a "run-off" mat intended for refrigerators
and freezers, which makes it easier to detect
possible leakage
Levelling
When placing the appliance ensure that it
stands level. If necessary adjust the feet us-
ing the adjustment spanner supplied.
Advertisement
Table of Contents
