Care And Cleaning - Electrolux ERES38810W User Manual

10 electrolux
temperature can be monitored. The meas-
uring shall be performed under steady-sta-
ted conditions (without changing the load).

Care and cleaning

Caution! Unplug the appliance before
carrying out any maintenance operation.
This appliance contains hydrocarbons in
its cooling unit; maintenance and re-
charging must therefore only be carried
out by authorized technicians.
Periodic cleaning
The equipment has to be cleaned regularly:
• clean the inside and accessories with luke-
warm water and some neutral soap.
• regularly check the door seals and wipe
clean to ensure they are clean and free
from debris.
• rinse and dry thoroughly.
Important! Do not pull, move or damage any
pipes and/or cables inside the cabinet.
Never use detergents, abrasive powders,
highly perfumed cleaning products or wax
polishes to clean the interior as this will dam-
age the surface and leave a strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliance with
a brush or a vacuum cleaner. This operation
will improve the performance of the appli-
ance and save energy consumption.
Important! Take care of not to damage the
cooling system.
Important! When moving the cabinet, lift it
by the front edge to avoid scratching the
floor.
Many proprietary kitchen surface cleaners
contain chemicals that can attack/damage
the plastics used in this appliance. For this
reason use a soft cloth rinsed in warm water
and neutral soap emulsion for cleaning ex-
ternal surfaces.
Important! Do not use detergents or
abrasive paste as these will damage the
paint, or stainless steel anti finger print
coating.
After cleaning, reconnect the equipment to
the mains supply.
Replacing the Taste Guard filter
To get the best performance the Taste Guard
filter once every year.
New active filters can be purchased from
your local dealer.
Refer to "Installation of the Taste Guard filter"
for instructions.
Replacing the water filter
Remove the filter. A small amount of water
will run out. Dry off and fit the new filter.
Refer to "Installation of the water filter"
Replacement filters can be ordered from
Electrolux Service Force Centre,
The water connection does not need to
be switched off when changing the filter.
Replacing the gas cylinder
Remove the gas cylinder, refer to "Installation
of the gas cylinder"