the length of the available travel in their slots.
This regains some up and down adjustment on
each of the 4 deck links.
1. Single-point-adjustment bolt
16.
Tighten the 2 bolts at the bottom of the
height-of-cut plate
Note:
For most conditions, adjust the black
blade tip 6.4 mm (1/4 inch) higher than the front.
17.
Torque the 2 bolts to 91 to 113 N∙m (67 to 83
ft-lb).
18.
Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck lift arm
assemblies.
Figure 85
(Figure
83).
g009042
63