Toro 72027 Operator's Manual page 62

1. Deck adjustment
2. Jam nut
10. Measure the rear blade tip height. Fine-tune the
rear adjusters as required; use the single-point
adjustment to gain more adjustment.
The rear tips of the side blades should measure
83 mm (3-1/4 inches).
11. Measure until all 4 sides are the correct
height. Tighten all the nuts on the deck-lift arm
assemblies.
12. Lower the discharge deflector.
13. If the 4 deck adjusters do not have enough
adjustment to achieve the accurate height of
cut with the desired rake, you can adjust the
single-point system
Figure 82
3. Adjustment nut
(Figure 83).
1. Single-point height
adjustment bolt
2. Front height-of-cut plate
g231991
mounting bolt
14. To adjust the single-point system, first loosen
the front and rear height-of-cut plate mounting
bolts (Figure
1. Mower deck
2. Front hole
15. If the deck is too low, tighten the single-point
adjustment bolt by rotating it clockwise. If
the deck is too high, loosen the single-point
adjustment bolt by rotating it counterclockwise
(Figure 85).
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
62
Figure 83
3. Rear height-of-cut plate
mounting bolt
83).
Figure 84
3. Back hole
g232012
g025558