Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Blaupunkt TPMS HN1.0
Summary of Contents for Blaupunkt TPMS HN1.0
- Page 1 HONDA PLUG & PLAY TPMS HN1.0 Enjoy it. Operating and Installation Instructions...
-
Page 2: Structure & Functions
Device is designed to monitor tire pressure and temperature only. Driver is responsible for the upkeep of the tires. Functions • Blaupunkt is not liable in case of loss of sensors. Con- tact your Blaupunkt dealer to purchase new sensors. Display External Sensor Valve Sensor... -
Page 3: Specifications
EXTERNAL SENSOR INSTALLATION SPECIFICATIONS Sensor Operating frequency 433.92 ± 0.05MHz Remove the valve cap. Tighten up the nut to the sensor by using Battery voltage 1.8V ~ 3.3V the spanner. Operating temperature -30°C ~ 60°C (External Sensor) -40°C ~ 105°C (Valve Sensor) Pressure range 0~8 Bar / 0~116 PSI Display... - Page 4 EXTERNAL SENSOR BATTERY REPLACEMENT VALVE SENSOR INSTALLATION Unscrew the nut. Replace new battery. Remove the original air valve from the Rebalance the wheel to ensure radial wheel barrel. uniformity. Install & adjust the valve sensor onto Unscrew the sensor. Refer to “Sensor Installation” steps. the wheel barrel.
-
Page 5: Display Installation
DISPLAY INSTALLATION DIFFERENT SCENARIO Disassemble blind switch from the original Embed the display with the into the trim ring High Temperature vehicle switch panel. empty switch slot. • Di- Di- Di- Di- Di- Front Left Front Right (FL) (FR) Rear Left Rear Right (RL) (RR) - Page 6 SETTING SETTING Sensor Pairing Setting • External sensor Tire Position Exchange Setting Thresold Value Setting - Disassemble the external sensor from (It is required only when the sensors has (It is required only when the tires has switched the front left tire & reinstalled, for Press &...
-
Page 7: Troubleshooting
SETTING TROUBLESHOOTING If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist. • Low Pressure Value Setting Interface Press OK button, then press the setting button to switch pressure unit. - Page 9 TPMS HN1.0E 1 311 21 010 45 01 TPMS HN1.0V Designed and engineered by Blaupunkt Competence Centre 1 311 21 011 45 01...
Need help?
Do you have a question about the TPMS HN1.0 and is the answer not in the manual?
Questions and answers