Table of Contents
Advertisement
Display icons
Indicates the current signal strength level (4 levels).
Indicates the night vision mode is on. The video turns black and white.
Indicates the screen off time is set.
Volume level setting (8 levels) is in progress.
Unable to detect the baby (camera) unit.
Indicates the current battery level (4 levels).
The alarm is on.
The speaker is muted.
The flashlight is on.
Zoom is set up.
Audio media is playing.
Note
Depending on the video settings, the display will go blank after 5 minutes, 15
minutes, or 30 minutes of inactivity to save power.
Registering the baby (camera) unit to the parent unit
(Pairing)
The video baby monitor is pre-registered to your parent unit. You do not need
to register it again unless the baby (camera) unit loses its link with the parent
unit.
To re-register your baby (camera) unit, see the following steps.
1.
Tap
on the menu bar.
2. Tap
and
3. Tap
/
starts searching the baby (camera) unit.
Note
A baby (camera) unit can be paired only to one parent unit each time. If a baby
(camera) unit is currently paired with the parent unit,
appear in black on the screen and cannot be selected. Select the grey one for
a new registration.
4. Press and hold PAIR on the underside of the baby (camera) unit for about
5 seconds until you hear 'Ready for pairing'. When pairing is successful,
Pair OK will appear on the screen. The video from the baby (camera) unit
will then appear.
12
/
/
/
/
/
to select a desired camera. The parent unit
Getting to know your baby monitor
will pop up.
/
/
/
will
Advertisement
Table of Contents
