Advertisement
Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20
centimeters (7.9 inches) between the radiator (antenna)and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
United States of America Authorized Channels
SonicWALL declares that the APL24-08F (FCC ID: QWU-08F) when sold in US is limited to CH1~CH11 by specified firmware controlled in the USA.
FCC
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution:
This device is for indoor usage to reduce potential for harmful interference to co-channel systems. Frequency and channels in 5.15-5.2 GHz band are restricted to indoor use by the FCC.
The APL24-08F device has been designed to operate with an antenna having a maximum gain of 2.5 dBi (2.4 and 5 GHz) RTNC connector and 3 dBi (2.4 and 5 GHs) RSMA connector.
Antenna having a higher gain is strictly prohibited. The required antenna impedance is 50 ohms.
Dynamic Frequency Selection(DFS) is required on all Wireless LAN Mater devices(usually Access Points) and Wireless LAN Clients (usually Wireless NICs) that operate within 5470 MHz –
5725 MHz. NSA 220W that have these frequencies and channels enable in this range comply with North American and International DFS requirements. Some frequencies are blocked, and
cannot be selected by theuser per each specific regional approval.
Specific to the USA; at the urging of the Federal Communication Commission(FCC) user/installers should avoid operation frequencies near Terminal Doppler Weather Radar (TDWR)
systems frequencies 5600-5650 MHz when installing NSA 220W within 35 km of line-of-site of TDWR sites. If TDWR is within 35 km the NSA 220Wt frequencies should be set to at least 30
MHz above or below any TDWR system frequency at that site. TDWR locations and specific frequencies used can be found at <
current and background information can be found at <
DFS band function is product dependent. Some products may not have DFS band function.
Industry Canada Notices
Authorized Channels
SonicWALL declares that the APL24-08F (IC: 4408A-08F) when sold in Canada is limited to CH1~CH11 by specified firmware controlled in theUSA.
Operation
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesiredoperation.
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed andoperated with
minimum distance 20cm between the radiator & your body.
Antenna
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This radio transmitter (IC: 4408A-08F) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain
and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having again greater than the maximum gain indicated
http://www.wispa.org/?page_id=2341
http://spectrumbridge.com/udrs/home.aspx>
>.
. Detailed
Advertisement
