6. Install the power supply assembly.
7. Connect the new power supply assembly cables to the system board.
8. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
E-lock
Prerequisite
Before you start, read Appendix A "Important safety information" on page 63 and print the following
instructions.
Note: To remove the screws, you need a special tool (T15 star wrench).
1. Remove the computer cover. See "Computer cover" on page 33.
2. Disconnect the E-lock cable from the system board.
3. Remove the E-lock.
.
Chapter 8
CRU replacement
57