Advertisement
Using Your Portable Steam Pocket
DIRECT SPRAY STEAM BOTTLE USE
Cleaning Tip: Direct steam spray for
cleaning hard to reach nooks & crannies
and stubborn sticky messes where
focused steam power may be needed.
Direct steam spray can loosen and
dislodge compact dirt often found
in corners and tight places where
traditional methods and cleaning tools
tend to push dirt into, making it difficult
to reach and clean. Spray direct steam
and wipe clean with a cleaning cloth.
CAUTION: Direct steam spray
temperature is extremely hot
closest to the nozzle and can
damage surfaces if held directly
focusing in one spot too long. Be
sure to constantly move and adjust
the steam spray to avoid causing
damage.
1
1
Attach the Steam Bottle Nozzle.
Aligning the arrow located on
the Steam Bottle Nozzle with the
Un-Lock symbol located on the
Nozzle Connector. Press in and turn
clockwise to secure into place. The
arrow on the nozzle will align with the
Lock symbol.
2
To remove the Steam Bottle Nozzle,
turn counter-clockwise to unlock and
remove.
4
TOLL FREE: 1-800-798-7398
SC630/SC630C_IB_En_090923.indd 4-5
1
3
4
HOSE & CLEANING TOOL
ATTACHMENT USE
1
Attach the hose connector. Aligning
the arrow located on the hose
connector with the un-lock symbol
located on the nozzle connector.
Press in and turn clockwise to secure
into place. The arrow on the hose
connector will align with the lock
symbol.
2
To remove the hose, press in and
turn the hose connector counter-
clockwise to unlock and remove.
3
Select the desired cleaning tool
for use. Follow the cleaning tool
sub assembly instructions for the
selected tool.
4
Attach the cleaning tool by inserting
the hose stem into the handle of
the cleaning tool. Press in and
turn clockwise at the same time
to secure and press in and turn
counter clockwise to release. Check
for proper connection by turning
the handle counter-clockwise a few
turns. The handle should remain
connected. (Note for reference:
This connection method is the
same design used with most over
the counter prescription bottles).
The design of this connection is to
prevent the hose from twisting and
kinking during
use.
5
6
WEDGE CLEANING TOOL ASSEMBLY
5
Slide the wedge shaped cleaning
pocket over the wedge cleaning tool
frame until it is completely on.
6
Secure the cleaning pocket onto the
frame. Close the cinch by pulling
on the elastic band and sliding the
locking bean to tighten.
Cleaning Tip: The wedge cleaning
pocket was designed for cleaning a
variety of surfaces and is exceptional
on those that are large and flat, both
horizontal and vertical. Broad cleaning
sides and super absorbent microfiber
fabrics loosen, lift, and lock in dirt and
grime while sanitizing at the same time.
Cleaning Tip: The wedge tip and
squared edges reach into tight areas
often missed or difficult to reach with
traditional cleaning methods. The
Wedge sides concave to wrap around
sink and faucet fixtures, door knobs, and
other small curved surfaces leaving them
clean all around. Multiple sides provide
more surface cleaning area and allow
one to clean with one side and finish
with the other for a "NOW YOU KNOW
THAT'S CLEAN" performance. Surface
examples for use are countertops,
tabletops, cabinets, walls, floor spot
cleaning, bathroom fixtures and more.
CAUTION: It is recommended that
you allow the cleaning pockets to
cool off before removing them from
the wedge or cylinder tools to avoid
possible scalding injury.
www.sharkclean.com
09/07/10 8:29 AM
English
5
Advertisement
