How To Use An Accessory Heater - Edic GALAXY 2000SX-HR Owner's/Operator's Manual

HOW TO USE AN ACCESSORY HEATER:

1. Fill the solution tank of your 2000SX-HR/2000IX-
HR extractor with sufficient water or solution for the
task at hand. Do not use water over 130 degrees F.
2. Mount the Heater by lining up the two mounting
legs (See #7 on page 8) to the two mounting brack-
ets on the rear of the machine (#11 on pages 6&7).
3. Connect your heater's inlet hose (#1 on page 8) to the
machine's outlet quick disconnect (#7 on pages 6&7).
4. Connect your 25ft solution hose
to the heater's Q.D. (#5 on page 8)
5. Connect your 50FT power cord to the twist
lock pigtail on the heater (#4 on page 8). Plug
the 50ft power cord(s) to the twist lock pigtail
on the back of the machine (#6 on pages 6&7)
6. Connect the power cord(s) to the machine and an
approved 15 amp outlet. If your machine is a 2000IX-
HR, each of the two cords must be on a separate 15
am circuit.
7. Connect your 25ft vacuum hose to the extractor's
vacuum inlet barb (#5 on pages 6&7)
8. Connect your vacuum and solution line to a carpet
wand or upholstery attachment.
9. COMPLETE THIS STEP BEFORE TURNING
HEATER ON: Turn the pump switch to the "ON"
position using the pump switch on the handle of
your 2000SX-HR/2000IX-HR. Pressing the solution
valve trigger of your attachment, spray water for 10-
15 seconds until you have a steady flow. This ensures
the heater is filled with fluid.
10. Turn heater on using the power switch (#2 on page
8) and allow up to 3 minutes for the unit to heat up.
11. The heater is ready for use once the green lamp (#3
on page 8) shuts off. Once you start cleaning, the
green lamp will turn on and off throughout your job
as the thermostats automatically regulate the tem-
perature.
8