Toro 414500000 Operator's Manual page 10

Power-Takeoff Switch (PTO)
Use the power-takeoff switch (PTO) to engage and
disengage mower blades or start and stop powered
attachments (Figure 4); refer to
Mower-Blade-Control Switch (PTO) (page
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated
4).
The MIL is the red light located in the console panel.
When the MIL illuminates, make initial troubleshooting
checks; refer to Troubleshooting (page
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance (Figure 5).
1. Safety-interlock symbols
2. Battery light
Safety-Interlock Indicators
Symbols on the hour meter indicate with a black
triangle that the interlock component is in the correct
position (Figure 5).
Operating the
16).
57).
Figure 5
3. Hour meter
Battery-Indicator Light
If you turn the key to the O
seconds, the battery voltage displays in the area
where the hours are normally displayed.
The battery light turns on when you turn the key to the
O position and when the charge is below the correct
N
operating level
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure
(Figure
Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O
Starting the Engine (page
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Fuel-Shutoff Valve
Close the fuel-shutoff valve when transporting or
storing the machine; refer to
Valve (page
g216020
10
position for a few
N
(Figure 5).
4).
, R , and S
FF UN TART
17).
Using the Fuel-Shutoff
23).
to F
LOW AST
. Refer to
(Figure 4).