Table of Contents
Advertisement
On-Chip IDE Controller
These items allow users to enable or disable the IDE controller.
PCI IDE BusMaster
This item allows you to enable/ disable BIOS to used PCI busmastering for
reading/ writing to IDE drives.
On-Chip SATA Controller
These items allow users to enable or disable the SATA controller.
I/O Device
Press <Enter> to enter the sub-menu and the following screen appears:
COM Port 1/ 2
Select an address and corresponding interrupt for the serial port1/ 2.
Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides
Standard, ECP, and EPP features. It has the following options:
[Disabled]
[3BC]
[278]
[378]
Parallel Port Mode
[Normal]
[EPP]
[ECP]
[ECP & EPP]
[Bi-Directional]
To operate the onboard parallel port as Standard Parallel Port only, choose
[Normal]. To operate the onboard parallel port in the EPP mode simultaneously,
choose [EPP]. By choosing [ECP], the onboard parallel port will operate in ECP
mode only. Choosing [ECP + EPP] will allow the onboard parallel port to support
both the ECP and EPP modes simultaneously.
Line Printer port 0
Line Printer port 2
Line Printer port 1
Standard Parallel Port
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port
BIOS Setup
3-13
Advertisement
Table of Contents
