Chapter 4 - Maintaining The Edlund Crown Punch Can Opener; Adjusting The Head - EDLUND 625M Safety & Operating Instructions Manual

CHAPTER 4 - MAINTAINING THE EDLUND CROWN PUNCH CAN OPENER

This chapter covers regular maintenance procedures that will ensure the best performance and long life of your
opener.

Adjusting the Head

BEFORE PERFORMING ANY MAINTENANCE, YOU MUST DISCONNECT THE OPENER FROM THE AIR SUPPLY.
1. Place the can that you want to adjust the machine to below and against the guard ring tab.
2. Loosen the four (4) "T" bolts at the rear of the vertical (Figure 3) and raise or lower the Head as needed,
keeping the can and guard ring aligned and level.
Tip: Placing a 1/8 to 3/16-inch thick shim between the can and guard ring will help.
3. Tighten the four (4) "T" bolts.
Punch Head
Head must be level
1/8" (3,2 mm)
to
3/16" (4,8m)
Thumb Screw
2X
Guard Ring Thumbs
crews
Edlund Company CROWN PUNCH CAN OPENER, Models 625M and 625
8
Ratchet Wrench
not shown
Can
Can
Ratchet Wrench not shown
Figure 3
Figure 3
"T" Bolts
"T" Bolts