Is The Motorcycle Ready To Ride; Pre-Ride Inspection - Xmotos XB31 Operating Instructions Manual

Before each and every ride you take, it is extremely important that you inspect the motorcycle and make
sure any problems you find are corrected. A pre-ride inspection is a must because off-road riding can be
very tough on a motorcycle and you do not want to have a breakdown for from help.
WARNING
Improperly maintaining your motorcycle or failing to
correct a problem before riding can cause a crash in
which you can be seriously hurt or killed. Always
preform a pre-ride inspection before any ride and
correct any problems.

PRE-RIDE INSPECTION

Check the following items before you get on the motorcycle:
Tires – Use a tire pressure gauge to check the air pressure. Inflate or deflate as needed. Also check for
signs of damage or excessive wear.
Spokes & Rims – Make sure all of the spokes are tight. Inspect the rim to be sure it is not bent.
Leaks – Look under the motorcycle for signs of leaking fluids such as engine oil or gasoline.
Engine Oil – Check the level of engine oil and add if needed.
Fuel – Check the level of fuel in the gas tank. Add if needed. Be sure the gas cap is tightened securely.
Drive Chain – Inspect the drive chain condition and slack. Adjust and lubricate if needed. Also check the
chain guide(s) and roller(s) for wear and replace if and when it is worn. For detailed instructions on drive
chain slack adjustment, see the Servicing section of this manual.
Brake Hoses – Inspect the brake hoses for leaks and replace if needed.
Nuts & Bolts – Inspect all accessible nuts and bolts. Tighten then if it is needed.
Spark Plug & Cap – Check the spark plug for looseness. Tighten if needed. Be sure the cap is pushed on the
spark plug and it is tight properly.
Check the following items after you get on the motorcycle:
Throttle – Check the throttle free-play and adjust if needed. Rotate the throttle to be sure it moves easily
and freely. Make sure that it snaps back to its closed position automatically when you release it in all
steering positions.
Brakes – Step on the rear brake lever and squeeze the front brake lever to be sure the brakes are working
properly.
Remember, be sure to take care of any problems you find or have your Xmotos dealer correct it before you
ride.

IS THE MOTORCYCLE READY TO RIDE?

24
NOTICE TO PARENTS
If a youngster will be performing any of the following
pre-ride inspection procedures, it is your responsibility
to provide careful supervision and make sure they are
performed safely.