INSTALLATION TIPS Wall locations The thermostat should be installed approximately 4 to 5 feet above the floor. Select an area with average temperature and good air circulation. Do not install thermostat in locations: • Close to hot or cold air ducts •...
Getting to know your thermostat Displays the user selectable setpoint temperature. Days of the Hold is displayed when week and time thermostat program is permanently overridden. System operation Button indicators: The COOL, options HEAT or FAN icon will display when the COOL, HEAT or FAN is on.
SUBBASE INSTALLATION Caution: Mercury Notice: All of Pro1’s products are Electrical Hazard mercury free. However, if the Failure to disconnect the product you are replacing power before beginning to contains mercury, dispose of it install this product can cause properly. Your local waste electrical shock or equipment management authority can give damage.
WIRING Caution: Electrical Hazard Warning: Failure to disconnect the power All components of the control before beginning to install this system and the thermostat product can cause electrical installation must conform to shock or equipment damage. Class II circuits per the NEC Code. Wiring If you are replacing a thermostat, make note of the terminal connections on the...
TECHNICIAN SETUP Gas or Electric Setup Gas: For systems that control the fan during a call for heat, put the fan operation switch to the GAS position. Electric: The thermostat operation switch should be put in the ELEC position. This setting allows the thermostat to operate the fan when the fan relay is connected to the G terminal.
TECHNICIAN SETUP MENU Technician Setup Menu This thermostat has a technician setup menu Configure the installer options as desired using the table below. for easy installer configuration. To set up the thermostat for your particular application: Use the keys to change settings and the NEXT STEP Press MENU button or PREV STEP key to move from one...
MOUNT THERMOSTAT & BATTERY INSTALLATION Mount Thermostat Align the 4 tabs on the subbase with corresponding slots on the back of the thermostat, then push gently until the thermostat snaps in place.
PROGRAMMING THE THERMOSTAT Set Time Follow the steps below to set the day of the week and current time: Press MENU Press SET TIME Day of the week will be flashing. Use the key to select the current day of the week. Press NEXT STEP The current hour is flashing.
PROGRAMMING THE THERMOSTAT You can use the table below to plan your customized program schedule. Programming Table Setpoint Setpoint Day of the Temperature Temperature Events Time Week (Heat) (Cool) Weekday Wake Leave Return Sleep Saturday Wake Leave Return Sleep Sunday Wake Leave Return...
32º to +105º (0º to +41ºC) Operating humidity 90% non-condensing maximum Dimensions of thermostat 4.7”W x 4.4”H x 1.1”D Contact Us Pro1 IAQ Inc. 1111 S. Glenstone Suite 2-100 Spring eld, MO 65804 Toll-free: 1-888-Pro1iaq (776-1427) Toll Number (Outside the USA): 330-821-3600 Web: http://www.pro1iaq.com...