Advertisement
9. Unit description
1. direction of rotation switch / switch-on lock
2. locking button for attachment
3. battery charge level indicator
4. rubber cap
5. charging socket for unit
6. on/off switch
7. LED lights
8. tool holder
10 Charging the unit's battery before use
NOTE! The battery is delivered partially charged. Ideally, charge the battery for at least 1 hour before use. This
ensures the full performance of the battery. You can charge the Li-ion battery at any time without shortening its
life. Interrupting the charging process will not damage the battery. If the battery charge level indicator lights up
red during operation, the battery has less than 30% of its capacity and should be recharged.
Never charge the battery tool if the ambient temperature is below 10 °C or above 40 °C. If a lithium-ion battery is
to be stored for a long time, the charge level must be checked regularly. The optimum charge level is between 50
% and 80 %. The storage climate should be cool and dry in an ambient temperature between 0 °C and 50 °C.
Start the charging process:
Connect the USB charging cable to an appropriate power source. The battery is charged when the battery charge
level indicator lights up green.
End the charging process:
Disconnect the charging cable from the power source. Disconnect the charging cable from the unit's charging
socket.
Accessories
WARNING! Before carrying out any work on the unit, make sure that the rotation direction switch is in the middle
position. This prevents the unit from being switched on unintentionally.
Assembly: First remove the rubber cap (4) from the tool holder. Now you can attach the supplied attachments to
the unit. To do this, put the attachment on the tool and turn it in the direction of the arrow so that the attachment
locks into place.
- With the torque attachment, screwing stops automatically as soon as the screw is tightened. To do this, set the
required torque as desired within the selectable levels.
- The angle attachment enables you to carry out right-angled screwdriving work.
- The cutting attachment enables you to cut soft materials, such as cardboard, carpet, fabrics, etc., up to a thickness
of 6 mm.
Disassembly: To separate the attachments from the unit again, press the locking buttons on the side. Now the
attachment can be pulled off towards the front. Then put the rubber cap back on the tool holder.
Replacing bits / screwdriver bits: Insert: Insert a bit into the tool holder. Removing: Pull the bit out of the tool
holder.
11. Start-up
Switching the cordless screwdriver on / off
Switching on: Press and hold the on/off switch to start up the unit.
Switching off: Release the on/off switch to switch off the unit.
Switching the direction of rotation
Clockwise rotation: Slide the rotation direction switch to the left. Press the on/off switch. You can now screw in
the screws.
Counterclockwise rotation: Slide the rotation direction switch to the right. Press the on/off switch. You can now
unscrew the screws.
Switch-on lock: Slide the direction of rotation switch to the centre position. The on/off switch is blocked. NOTE:
When the on/off switch (6) is locked, it is still possible to activate the LED lamps (7). To do this, press the on/off
switch (6).
Tips and tricks Screw bits are marked with their dimensions and shape. If you are unsure, always try out first
whether the bit sits in the screw head without play. This ensures optimum power transmission and undamaged
screw heads.
4
Advertisement
