Advertisement
GB
Gigabit Fiber Ethernet Converter
10/100/1000Base-T/TX to 1000Base-SX/LX
User's Manual
Overview
Gigabit fiber media converter is a 10/100/1000 auto negotiating media converter. The copper port
auto negotiates the connected device's speed and duplex mode: 10/100/1000Mbps half duplex;
or 10/100/1000 Mbps full duplex; the fiber port always operates at 1000Mbps. The maximum
distance is Multi-mode 0.5 or 2km and single-mode 10/20/40/60/80km or 160km.
There is also 10/100/1000Base-T to SFP (mini-GBIC) media converter available. The SFP slot
supports both Multi-Mode (SX) and Single-Mode (LX) fiber standards for transmission distances
of up to 80km. Gigabit Ethernet port Auto-Negotiate between 100 and 1000Mbps transmission
speeds. Note: DN-82131 support 1000Base-T only.
Advertisement
Table of Contents
Related Manuals for Digitus professional DN-82110
Summary of Contents for Digitus professional DN-82110
- Page 1 Gigabit Fiber Ethernet Converter 10/100/1000Base-T/TX to 1000Base-SX/LX User’s Manual Overview Gigabit fiber media converter is a 10/100/1000 auto negotiating media converter. The copper port auto negotiates the connected device’s speed and duplex mode: 10/100/1000Mbps half duplex; or 10/100/1000 Mbps full duplex; the fiber port always operates at 1000Mbps. The maximum distance is Multi-mode 0.5 or 2km and single-mode 10/20/40/60/80km or 160km.
- Page 2 Installation 1. Interface RJ-45 interface The transmission media adopts CAT5 twisted-pair with typical length of 100 meter. It features the function of automatically identifying the through line and cross wire Fiber interface Fiber interface is of duplex mode type, including two interfaces, namely TX and RX. When the two sets of optical transceiver are interfaced or connected to switch with fiber interface, the fiber is in cross connection, namely "TX-RX", "RX-TX"...
- Page 3 Table 4: Back panel for fiber media converter DIP Switch settings instruction DIP-Bit Number Switch Status Function Descriptions LFP function enabled LFP function disabled OFF/OFF OFF/ON III. Electrical port is forced to 10M Electrical interface of 10M/100M/1000M adaptive Explanation for LED indicator LED indicator serve as device monitoring and trouble display.
- Page 4 Technical parameters: Standard Protocol: IEEE802.3 10 Base-T standard IEEE 802.3u 100Base-TX/FX standard IEEE 802.3z 1000Base-TX/FX standard Connector: one UTP RJ-45 connector, one SC/ST/SFP connector Operation mode: full duplex mode or half duplex mode Environmental temperature: 0°C-60°C Relative humidity: 5%-90% TP cable: Cat5 UTP cable Transfer fiber: multi-mode: 50/125, 62.5/125 or 100/140μm single mode: 8.3/125, 8.7/125, 9/125 or 10/125μm...
Need help?
Do you have a question about the DN-82110 and is the answer not in the manual?
Questions and answers