About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
Steps
1. Disconnect the I/O board-cable from the connector on the system board.
2. Disconnect the speaker cable from the connector on the system board.
3. Unroute the speaker cable from the routing guides on the palm-rest and keyboard assembly.
4. Remove the speakers from the chassis.
Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
If the rubber grommets are pushed out when removing the speakers, push them back in place before replacing the
speakers.
The following images indicate the location of the speakers and provide a visual representation of the installation procedure.
46
Removing and installing components