6. Connect the keyboard-cable to the connector on the touchpad module close the latch.
7. Connect the touchpad cable to the connector on the system board and close the latch.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
Steps
1. Remove the two screws (M2.5x4) that secure the right display hinge to the system.
2. Lift the right display hinge in upward direction away from the system.
3. Disconnect the power-adapter port cable from the connector on the system board and remove the power-adapter port from
the system board.
44
Removing and installing components
After working inside your
Before working inside your
computer.
computer.