Pc With Ethernet Adapter - D-Link DSL-2500U Quick Installation Manual

DSL-2500U
CONNECTING TO PC

PC with Ethernet Adapter

1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between the Ethernet port located on the back
panel of the router and the Ethernet port of your PC.
3. Connect a phone cable between the DSL port of the router and the ADSL
OUT port of the splitter. Connect your phone to the PHONE port of the
splitter. Then connect another phone cable between a phone jack and the
ADSL IN port of the splitter.
4. Connect the power cord to the power connector port on the back panel of
the router, then plug the power adapter into an electrical outlet or power
strip.
5. Turn on your PC and wait until your operating system is completely
loaded.
Now you should configure your PC to obtain an IP address automatically (as
DHCP client).
Quick Installation Guide
3