Servicing The Fuse; Servicing The Headlights - Toro Wheel Horse 16-38HXL Operator's Manual

Servicing the Fuse

The electrical system is protected by fuses. No maintenance
is required, however, if a fuse blows check the circuit
wiring for a short. To replace a fuse, pull up (Fig. 30) to
remove it from the socket. Push down to insert it.
Fuses: 10 amp, blade-type
Figure 30
1. Fuse (removed)

Servicing the Headlights

Use a #1156, automotive-type bulb.
Removing the Bulb
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood. Pull the wire connectors off of both of
the bulb holder terminals.
6. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 31).
1
2
m-1672
2. Socket
28
5
3
2
4
Figure 31
1. Bulb holder
2. Reflector
3. Tabs
7. Push and rotate the bulb counterclockwise until it stops
(approximately 1/4 turn) and remove the bulb from the
bulb holder (Fig. 32).
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 32). Push and rotate the bulb
clockwise until it stops.
2
4
3
Figure 32
1. Bulb
2. Metal pins
2. The bulb holder has 2 tabs (Fig. 31). Align the tabs with
the slots in the reflector, insert the bulb holder into the
reflector, and rotate it 1/4 turn clockwise until it stops.
3. Push the wire connectors onto the terminals on the bulb
holder.
5
1
4
m-1874
4. Slots
5. Terminals
1
2
4
m-1875
3. Bulb holder
4. Slots