Operation; Installation; Danger Of Fire - Equinox Systems HP 1500 User Manual

Operation:

Place the unit on a level surface.
Always disconnect it from the mains supply before filling as fluid could be spilled.
Fluid replenishment:
Always fill the tank away from the unit to prevent fluid getting inside the main housing.
If fluid should get inside the main housing, disconnect the unit from the mains immediately
and consult a technician.
Power the fixture down using the on/off switch on the rear panel and unplug the power cable. Turn the
fluid bottle lid counter-clockwise to unscrew and remove the fluid tank from the main housing.
Fill the tank with fluid and place the tank back in the housing. Place the lid on the fluid bottle and turn
clockwise to tighten. Plug the power cable back into the unit and power it on using the on/off switch
on the rear panel.

Installation:

Install the unit in a well-ventilated area. Use in an insufficiently ventilated room can lead to the
condensation of the haze fluid. The resulting slippery surface can cause accidents. Keep a minimum
distance of 1m around the unit.
Furthermore do not orientate the output aperture directly in the direction of the audience's eyes.
In order to create the best effect, there should be a distance between the unit and the audience
of at least 3m.
Only install the haze machine on fire resistant, scratch resistant and water resistant surfaces.
When installing the unit, make sure there is no highly flammable
material (decoration articles etc) within a minimum distance of 1m
Only use quality haze fluids recommended by your dealer. You must
not use substances which are classified as 'DANGEROUS WORKING
www.prolight.co.uk

DANGER OF FIRE!

DANGER TO LIFE!
Disconnect from the mains before starting maintenance
MATERIALS' or 'FLAMMABLE FLUIDS'.
Operating instructions
HP 1500 DMX Fogger User Manual
5