Special Product Features - LaserLiner CompactPlane-Laser 3G Operating Instructions Manual

Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents,
scouring agents and solvents. Remove the battery(ies) before storing for
longer periods. Store the device in a clean and dry place.
!
When transporting, always switch off all lasers, secure pendulum
and push the slide switch (3) to the right.

Special product features

Automatic alignment of the device with a magnetically
dampened pendulum system. The device is brought into
initial position and aligns itself autonomously.
Transport LOCK: The device is protected with a pendelum lock
during transport.
GRX-READY technology enables line lasers to be used even
in unfavourable light conditions.The laser lines pulsate at
a high frequency and this can be picked up by special laser
receiversover long distances.
The tilt function is not active following switch-on. Once the
device has been set up, press the tilt button to activate the tilt
function, enabling you to protect the laser from changes in
position caused by the device being disturbed by external
factors. The tilt LED flashes to indicate that the tilt function is
active. If the position of the laser was shifted through external
factors, a signal sounds, the laser flashes and the tilt LED
lights up continuously. Press the tilt button twice to continue.
Erroneous and inaccurate measurements are thus prevented
simply and reliably.
The tilt function does not activate monitoring until 20 seconds after the
!
laser has been fully levelled (set-up phase). The tilt LED flashes every
second during the set-up phase, and flashes rapidly when tilt is active.
CompactPlane-Laser 3G
15
EN