General Information
The unit displays Power on during initial power-up and advances to display the Home Screen.
All user accessible functions are easily set from the Home screen:
BAS-SVU040G-EN
Occupancy
Status
Temperature
Fan Mode
Heat/Cool Mode
• Occupancy Status: displays either Occupied, Unoccupied, or Temp Hold to indicate current occupancy
mode.
• Fan Status: when fan is running, exterior circle indicates current fan speed.
– No Segments: Fan is OFF
– One Segment: 1% to 33%
– Two Segments: 34% to 66
– Three Segments: 67% to 100%
• Setpoints: When Heat/Cool Mode is Cool Only or Heat Only, the current setpoint in use is displayed in the
center of the setpoint control bar.
When mode is Auto or Off, the cooling setpoint is displayed just below the red bar and the heating setpoint
is displayed just above the blue bar.
• Message Line: displays information regarding the current state of the equipment.
– Please adjust clock: verify the date/time information is correct.
– Shed demand: a demand shed signal is present and the sensor is controlling to demand shed setpoints.
– Shed cancel: a demand shed signal is present and the user has overridden the demand shed signal. The
zone sensor controls to the occupied setpoints.
– Contact service: the zone sensor has detected an HVAC equipment temperature sensor failure,
economizer fault, or loss of communication with the HVAC equipment.
Fan Status
Increment Up
Cooling Setpoint
Heating Setpoint
Increment Down
Schedule Menu
Override
Message Line
Please adjust clock
3